Search results

...e SI standard pressure is 100 kPa, which corresponds to the standard molar volume of an ideal gas of 22.711 L∙mol^-1 and 22.689 L∙mol<sup>-1</s

'lv' is short for the 2ml-chamber (large volume), 'sv chamber' is the small volume chamber ::::* Titration volume ('''2-mL''' O2k-chamber): '''[[Has lv titration vol::{{{lv titration vol}}}

...substance B given in moles. The definition applies to pure substance. The molar mass allows for converting between the mass of a substance and its amount f ...(with a gas phase), the concentration of the gas increases, when pressure-volume [[work]] is performed on the system.-->

...density ''ρ'', but is used for many [[extensive]] quantities divided by [[volume]] or area. ...ing the [[Faraday constant]]. Charge density in electricity is 'charge per volume'.

...''V'' of the mixture, whereas ''density'' is related to samples S or s per volume ''V''_S = ''V'' or ''V''_s < ''V'', respectively ([[BEC

::::::» [[Volume]] ::::::» [[Molar mass]]

|molar mass=180.16 ...o take the volume of the solute into account (see: [[Volume_of_the_solute| Volume of the solute]]).

.../]]: list of pages edited to give instructions for titrations in the small volume chamber. Here is another test page for the sV-chamber projekt: [[/Digitonin * DONE: [[/FW replaced/]]: we want to have molar mass instead of FW. (2021-02)

...b>G</sub> of the ideal gas is 22.414 L/mol at 0 °C, whereas the real molar volume of O₂ is ''V''_m,O₂(g) = 22.392 L/mol at 0

...to be prepared directly before using it like Pyruvate. In these cases the volume contributed by the solute was tested. ...was [[TMPD]], 200 mM. The dry substance contributed only about 3 % to the volume of the stock solution. Therefore further tests were focused on stock soluti

...re of the gas, ''α'' has the dimension of volume of the gas ([[STPD]]) per volume of the solution per partial pressure of the gas.

|molar mass=161.2 ::::* Titration volume ('''2-mL O2k-chamber'''): 4 µL using a 10 µL Hamilton syringe.

|molar mass=65.01 ...to take the volume of the solute into account (see [[Volume_of_the_solute| Volume of the solute]]). The concentrations prepared following the former instruct

...lar [[format]], advancement is expressed in the same unit as amount [mol]. Molar advancement and amount are distinguished as the dynamic expression related ...bs energy) and [[Intensive quantity |intensive quantities]] (expressed per molar advancement; Gibbs [[force]]).

* <u>''n''</u>: chemical or molar format of amount; MU = mol * <u>''V''</u>: volume format; MU = m³

|molar mass= 183.91 ::::# Under a fume hood, dissolve in a volume of distilled H2O lower than 10 mL, using a borosilicate Erlenmeyer flask or

|molar mass=104.06 ...0.8 mg malonic acid into a Eppendorf tube of appropriate volume (for final volume of 100 µL).

|molar mass=198.11 ::::# Adjust final volume to 5 mL and divide into 0.2 mL portions in dark vials.

|molar mass= 177.14 ::::* Titration volume: 2 µL using a 10 µL syringe (2 mL O2k-chamber).

|molar mass=41.99 ::::* Titration volume: 20 µL using a 25 µL syringe (2 mL O2k-chamber).